Up to 100 designs can be saved to the memory and memory capacity is two million stitches. Design angle can be modified by 1˚ for angles between 0˚ and 359˚, and mirror image can be converted (X-axis conversion). Embroidery design can be enlarged or reduced by increments of 1% within the range between 50% and 200% to the direction of X and Y-axis. Same design can be repeated up to 99 times to the direction of X-axis and Y-axis. A number of designs can be repeated while modifying mirror image and angle. Special repeat work can be set up to 63. Frame is automatically returned to the offset point when embroidery is finished to ease embroidery replacement process. Frame replacement can be done at a desired position by configuring automatic offset from parameter setting mode. Frame can be manually moved from a pre-set position for better applique and frame replacement during the embroidery. Frame can be returend to its original position by simple key control. Frame can be returned to its starting point during the embroidery. By the units of 1, 100, 1000, and 10000 needles and color code unit, needle bar can be moved forward and backward without actual embroidery. When a thread falls off or becomes cut, frame can be returned to the starting point 1 - 10 times. Frame can be automatically returned to the exact last position before power shortage and this function greatly reduces defects in complete products. Stitch data and function code (jump, exit, trim) can be deleted, modified, inserted. Head with the cut thread can be separately controlled from other heads.